New pattern

The pattern for the Monster High boots in the previous post is now available on my web site.

Stretchy boots for Monster High dolls

Monster High dolls' legs are so thin that boots with zippers or laces would be hard to make, so I decided to try stretchy fabric instead.

After cutting the pieces, I sewed the back seam and made the soles (two layers of cardboard plus leather insole).


Then I put the uppers on the doll's feet, put the soles in place, and trimmed, turned and glued the uppers under the soles.


As you can see in the previous photo, there was a lot of extra fabric, but when you trim it properly, the result is neat.


I made the heels out of wood. I had some round strips of wood and decided to see how that would work. I sawed the upper parts of the heels in 45 degree angle using a mitre box. Then I measured the height of the heels and sawed them off of the strip.


Next, I used a craft knife to make the front of the heel straight.


Then I covered the heels with the same fabric I used for the uppers.


Finally, I glued pieces of leather to the bottom of the heels, glued the heels in place, and glued pieces of leather as outer soles.

Here are the finished boots on Draculaura:

Platform shoes for a Monster High doll

I had several pairs of the plaster casting soles, so I decided to make another pair of platforms. These are basically similar to the orange silk shoes I made earlier, only the ankle strap is different.

I glued the front parts of the insoles (from toes to about middle of the arch) in place before gluing the straps in place. If the strap construction is anything more complicated, it is better to do it first, but in this case only the end of the vertical strap needed to be glued under the insole.


Here is a closeup of the strap construction.


And here are the finished shoes.

New shoes for Catwalk Kitty Jet

I tried to find a photo of how these looked originally, but couldn't find any. I guess I didn't take it, although I remember that I intended to. I started painting these a long time ago, but only now got them finished.


Catwalk Kitties have similar foot mechanism as Bratz dolls, so it is easy to replace their original feet. I have mostly used ankle boots on them, but wanted to try this too.

I first painted everything with black acrylic paint. You can't use solvent-based paints directly on vinyl dolls as the paint won't dry. However, with a couple of coats of acrylic paint first, it was possible to use Humbrol paints for the shoes.

I finished the black parts with satin sealer, which gives a surface that is close enough match to the doll's legs.

Here is the doll in her new shoes:

Monster High shoes with plaster casting soles

It has been some time since I last made any doll shoes. This pair has remained unfinished since March, but I finally decided to finish it.

The soles are plaster castings made with latex moulds. I glued fabric on the sides of the soles and on top of the inner soles made of cardboard.

After gluing the straps in place, I glued the inner soles to the plaster castings and glued in place the outer soles made of leather.