Another pair of ankle boots

I wanted to make a white pair of ankle boots for Spectra the same way I made greyscale Ghoulia's boots. The photo below shows a closeup of the material I planned to use. It's half fabric, half some sort of plastic.

Here are the main parts for the boots with the plastic side (outside) facing up.

I used these scissors for cutting some edges. As these are actually meant for cutting cardboard, they were not sharp enough for soft plastic and I had to finish the cutting with regular scissors.

I tried gluing the back seams, but that didn't hold, so I decided to sew them.

I also sewed the front seam. As the fabric side was inside, gluing the uppers in place was not a problem.

This time I glued the toe part in place at this point, which actually turned out to be the better way to do it.

Then I made the button holes.

The heels are made of wood again, but I decided to paint them, because the plastic material was too thick for covering them.

Then I sewed the buttons in place the same way as previously, glued the heels in place, and glued pieces of leather as outer soles.

Here are some photos of the finished shoes.