Pages

Saturday, December 19, 2020

Simple loafers

This is the sole I made for the Kindi Kids sandals. You just trace the doll's foot on paper and then shape the sole around it. This time I used it for making loafers out of felt.



Here are the pieces for the shoes. The grey soles are made of thick felt (0.3 mm) that is made of recycled textiles. The red parts are made of thinner felt I bought from a supermarket's crafts section. The uppers are shaped using the sole pattern and adding a small bit that won't be sewn into the side pieces, so it will turn up along the top of the foot.



I sewed the side pieces to the soles and then the back seam. Then tried this on the doll to check how it looked like.



The sides of the toe part were too high, so I adjusted them while the doll's foot was inside the shoe. Then I wrapped the remaining side piece around the shoe to adjust it the same way before sewing it in place in the other shoe.



Then I sewed the uppers in place. At this point I realized that the upper should have been narrower than the sole, but I wasn't going to undo anything and just accepted that this first try wasn't going to be a success. The soles need to be smaller anyway, so I'll make all the necessary adjustments in the next pair of loafers.



Here are the finished shoes on the doll. Not totally awful, but definitely in need of improvement. This doll's feet are so oddly shaped that it is a challenge, but I'm sure I'll be able to make a nicely fitting pair eventually.




No comments:

Post a Comment